View Profile: Jonathon - Advanced Flight Forums

01-30-2023, 02:56 PM

Jonathon replied to a thread AFS 4500 with Floscan 200 in AF-3400s, AF-3500s, AF-4500s ... General Discussion

AFS k-factor value is just counts per gallon / 100. So if your k-factor was 30,000 on a Dynon system you should start with 300 on your AF-4500.

2 replies | 65 view(s)

01-24-2023, 03:40 PM

Jonathon replied to a thread Red Xs asserting at ~10sec interval in AF-5600 & AF-5500 General Discussion

Sounds like this ADAHRS probably needs to get sent in for a look. I've created a support ticket for our folks at Dynon to reach out about a possible...

11 replies | 425 view(s)

01-17-2023, 10:04 AM

Jonathon replied to a thread Red Xs asserting at ~10sec interval in AF-5600 & AF-5500 General Discussion

Is your transponder cable run anywhere near the ADAHRS or ADAHRS cable? If it is try pulling the transponder circuit, see if the problem persists.

11 replies | 425 view(s)

01-16-2023, 03:05 PM

Jonathon replied to a thread RV-12iS in AF-5600 & AF-5500 General Discussion

You need the EMS-221. The ULPower ECU talks over CAN, not RS-232. The EMS-221 is necessary for the EFIS to read CAN.

9 replies | 74644 view(s)

01-16-2023, 03:02 PM

Jonathon replied to a thread 6600 expansion connector in AF-5600 & AF-5500 General Discussion

Yes, since your AF-GPS is just a rebranded SV-GPS-250.

3 replies | 96 view(s)

01-16-2023, 10:53 AM

Jonathon replied to a thread 6600 expansion connector in AF-5600 & AF-5500 General Discussion

Negative, this is only 5V on pre R7 AF-5000 hardware. For R7 AF-5000 and AF-6000 hardware, pin 1 is 8V to power SV-GPS-250 or GPS-2020 modules.

3 replies | 96 view(s)

01-11-2023, 12:56 PM

Jonathon replied to a thread ACM Wiring in AF-5600 & AF-5500 General Discussion

Both are switched through pins on the ACM Panel Switches connector. The cabin lights circuit can be set always hot in the SET --> CAL --> Electrical...

1 replies | 123 view(s)

01-10-2023, 12:33 PM

Jonathon replied to a thread Questions about VFPL functionality in AF-5600 & AF-5500 General Discussion

Yes this would be fine Correct when VFPL is active, the autopilot will not chase the altitude bug. Yes an annunciator warning will...

5 replies | 207 view(s)

01-10-2023, 11:36 AM

Jonathon replied to a thread Aithre 2.0 CO wiring in AF-5600 & AF-5500 General Discussion

74262 Aithre EX 3.0 Analog Wiring.pdf The dsub is optional but recommended (or use your preferred disconnect) The EX 2.0 will not have the...

1 replies | 90 view(s)

01-10-2023, 11:15 AM

Jonathon replied to a thread Red Xs asserting at ~10sec interval in AF-5600 & AF-5500 General Discussion

Well it sure was a convenient theory. On the SET --> CAL --> Advanced SV Network menu, does the firmware for the ADAHRS match the firmware for the...

11 replies | 425 view(s)

01-09-2023, 02:56 PM

Jonathon replied to a thread Red Xs asserting at ~10sec interval in AF-5600 & AF-5500 General Discussion

I assume this is in pertains to the Tehachapi build-a-plane CH750? I told one of your partners last month to check the OAT wiring. Are you aware of...

11 replies | 425 view(s)

01-06-2023, 05:45 PM

Jonathon replied to a thread Questions about VFPL functionality in AF-5600 & AF-5500 General Discussion

If you enter a VFPL profile to the currently active leg, it will push the TOD out all the way to the end of the leg, as far out as it can with...

5 replies | 207 view(s)

01-06-2023, 04:01 PM

Jonathon replied to a thread Stormscope WX-500 and 5600 in AF-5600 & AF-5500 General Discussion

Although there is a WX-500 option in the serial port choices already, it admittedly does not function. Stormscope support is on the backlog of...

2 replies | 105 view(s)