View Full Version : Angle, angle push, even after landing

08-20-2013, 09:40 PM
I took the time finally to calibrate the AOA Sport in my plane this afternoon. I have been flying the plane with the CB pulled all of this time because I didn't have time to do the calibration.

Anyway, the AOA seemed to work fine until after I landed with full flaps and on flare and as I rolled down the runway to enter upcoming taxiway the AOA kept barking "Angle, angle, push." I raised the flaps, no change. I ended up pulling the breaker again.

So, is this a calibration issue that I didn't do correctly or is this an installation problem?

Thank you!

Rob Hickman
08-21-2013, 08:16 AM
Do another hangar calibration and you might need to do another flight calibration.

08-22-2016, 02:37 PM
Isn't there just a value airspeed that you can set to eliminate aoa on landing?