View Full Version : Magnetic Calibration Error
brianjohnson
07-21-2013, 08:02 AM
When trying to do a magnetic calibration, I always get an error data points not being elliptical.
DickF
07-21-2013, 11:04 AM
I had a similar problem - turned out that it was caused by the rebar in the ramp. I now do my calibration on an asphalt ramp.
Hope this helps,
Dick
brianjohnson
07-22-2013, 11:16 AM
Maybe I was too close to the hangars. There's a giant asphalt ramp that is completely empty, I'll take it out there and try it again. Thanks!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.