PDA

View Full Version : Manifold Pressure AN471-4D Assembly



schmoboy
04-04-2013, 07:16 AM
I acquired an AN471-4D Aeroquip fitting as recommended in the manual to connect the manifold pressure to the transducer. I need some help with how the fitting is supposed to be connected.

A bit hard to explain in words and probably using the wrong terms, but...

I assume that the aeroquip hose is inserted into the knurled portion, then the nipple is inserted into the AN female and connected to the flex hose from the cylinder. Then the aeroquip hose and knurled end is tightened onto the nipple/AN which should already be tight on the flex hose. I assume tightening the nipple into the knurled end will expand the aeroquip hose and make it a tight fit?

Rob Hickman
04-04-2013, 08:34 AM
Sounds correct to me.

schmoboy
04-04-2013, 08:37 AM
Thanks Rob...