View Full Version : Flight Data Systems
CharlieWaffles
09-09-2012, 07:29 PM
The Flight Data Systems GD-40 CO2 detector is reported to work with the AFS EFIS system. Is there any information on how it is wired into the harness?
Roy Thoma
09-10-2012, 06:55 AM
Mark,
The Flight Data Systems GD-40 is a CO detector, not a CO2 detector. CO is poisonous, C02 is not. Looks like a good value.
The GD-40 uses a serial interface. From the Flight Data Systems web site (at http://www.fdatasystems.com/Downloads/Downloads.html):
"RX (Serial Receive) Connect to EFIS serial port “Transmit”.
TX (Serial Transmit) Connect to EFIS serial port “Receive”.
(Use a two conductor shielded wire for the data connection. Connect one end of the shield to ground) "
Probably wired to any available serial port, similar to the CO Guardian. From page 92 of the version 2.6 5000 series manual:
"The CO Guardian should be wired to any open serial port and then the serial port Admin setting set to CO Guardian."
Regards,
Roy
stickandrudderman
09-11-2012, 03:51 PM
I've not come across these people before and am interested in the CO detector. Any more feedback on this?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.