Angier Ames
03-25-2012, 07:30 AM
My AOA Pro is in a Lancair 360 installation and not yet calibrated.
On startup I get the message "landing gear" and "AOA pass" and the AOA audio flows through a PS Engineering PMA4000.
When depressing the flap switch, the green donut toggles on or off but there is no audio "Flaps".
What could I have done incorrectly?
Thanks
On startup I get the message "landing gear" and "AOA pass" and the AOA audio flows through a PS Engineering PMA4000.
When depressing the flap switch, the green donut toggles on or off but there is no audio "Flaps".
What could I have done incorrectly?
Thanks