davehead
02-23-2012, 11:43 PM
The AF-3000-4000 System Manual (page 84) says “AF-3400/3500 systems are shipped with all sensors except Fuel Tanks and Trim / Flap sensors fully calibrated. Individual sensors should not need to be adjusted unless a new sensor is installed.” Does this mean that if I purchased my oil pressure, fuel pressure, oil temp, Hall-Effect amps transducer, OAT, manifold pressure, EGT and CHT sensors from AFS in a separate order from the 4500, then I must adjust them? If yes, how do I do that? If no, then what situation does the manual refer?
My oil and fuel pressure are measuring 4 & 7 PSI with no oil or fuel in the engine. Should I adjust these to read 0 by simply changing the “Shift Adjust” values?
The AF-3000-4000 System Manual also says “The Amps transducer (Hall or Shunt) will need to have the zero current point set.” Do I accomplish this by simply changing the “Shift Adjust” value?
Thanks for your help.
My oil and fuel pressure are measuring 4 & 7 PSI with no oil or fuel in the engine. Should I adjust these to read 0 by simply changing the “Shift Adjust” values?
The AF-3000-4000 System Manual also says “The Amps transducer (Hall or Shunt) will need to have the zero current point set.” Do I accomplish this by simply changing the “Shift Adjust” value?
Thanks for your help.