View Full Version : Secondary ships battery monitor
capdave
08-25-2020, 09:49 AM
Hello,
We are upgrading to the ECB ACM this week because we want the built in backup alternator support. We are flying with an EFII electronic ignition system and its bus manager. i see the pin assignments for the two field wires, but am not finding where to input the secondary ships battery. Thanks!
Shawn McGinnis
08-25-2020, 02:43 PM
If you are trying to tie the second battery power input into the ACM that's setup is outside the scope what the ACM handles. You would need to combine/isolate the batteries external to the ACM.
If you are trying to measure the second battery then it depends on which EFIS is being used AF-5000 or SkyView with EMS?
capdave
08-27-2020, 12:13 PM
Hi,
This is an AF-5000 with the ECB ACM.
Yes, all we are trying to do is measure the second battery. What pin of what connector does this tie into?
Thanks!
Shawn McGinnis
08-31-2020, 09:03 PM
Pin 13 on the EFIS Expansion connector (https://www.advancedflightsystems.com/drawings/53602WD-AF-5000-R7-EFIS-Main-Harnesses.pdf) is where Volts 2 is on the AF-5000 Series displays. This pin isn't pulled through into the ACM.
capdave
09-01-2020, 10:14 PM
Thank you!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.