View Full Version : Adsb report
rvdave
11-30-2018, 12:17 AM
This is info received
http://i67.tinypic.com/1124kyv.png
http://i66.tinypic.com/4sgu1y.png
http://i67.tinypic.com/2v1w2l3.png
Shawn McGinnis
12-03-2018, 09:46 AM
What GPS is driving your transponder? Which transponder are you using? Do you have the transponder setup properly in the Transponder settings page?
rvdave
12-03-2018, 10:26 AM
Ifd540 driving transponder, sv261, mode s, aircraft Id set correctly all screens, resistor to pin 3 input. Not sure of any other settings on 540 but is set according to Quick panel instructions.
Shawn McGinnis
12-03-2018, 11:24 AM
On the AF-5000 verify your GPS Settings on the Transponder setup page. You should have AVIDYNE (Avi) selected.
On the 540 you should have ADS-B (Avi) as an RS232 output channel.
If this is correct you may need software updates in one or both of the devices.
rvdave
12-10-2018, 09:05 AM
I had a wrong setting on setup for gps, I had afs250, changed it to avi but now I get no response from adsb website where I could check the info. My transponder shows updated, have current afs software. I will verify by setting back to afs250 to be sure that’s the only variable in case I set something unaware.
rvdave
12-18-2018, 01:19 PM
Had a disconnected wiire from gps to transponder.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.