View Full Version : Uavionix ADS-B self as traffic
rwayne
02-05-2018, 06:36 AM
I just replaced my Navworx ADS-B with the Uavionix and my 5600 is showing my plane as traffic. I have my tail number and ICAO hex entered in the transponder config settings. Any idea how to correct this?
Shawn McGinnis
02-05-2018, 10:27 AM
Check your
Ronsim
02-06-2018, 12:06 PM
Be sure your N no. and ICAO code are on your "setup" screen --- I had the same issue -- the ghosting went away once the AFS knew who I was.
Ron
rwayne
02-07-2018, 07:52 AM
That did it! I had not set up the Echo correctly. Thank you.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.