PAN-Denmark
04-17-2017, 09:27 AM
Hi,
I have tried to setup the two tanks on my RV-6A in my AFS 5600. I have measured the resistance in the float sensors with ground and get variable numbers depending on how much fuel is in the tank - so that part is working (also the sensors worked before the "makeover").
When I connect the single wire from left tank to pin-20 (internal EMS board) on the 37-pin d-sub and right tank to pin-21 I get no AD_Value on neither tanks. I tried with empty tank and adding fuel but no changes.
If I switch and connect to 22 and 23 instead (tanks 3 and 4) I can get the right readouts. Am I doing something wrong ? The meters for tanks 3+4 are much smaller and I would prefer to have the sensors on tanks 1+2 which are much more readable.
Can I totally reset the tanks and start over ?
cheers
Per A.
RV-6A, Denmark
I have tried to setup the two tanks on my RV-6A in my AFS 5600. I have measured the resistance in the float sensors with ground and get variable numbers depending on how much fuel is in the tank - so that part is working (also the sensors worked before the "makeover").
When I connect the single wire from left tank to pin-20 (internal EMS board) on the 37-pin d-sub and right tank to pin-21 I get no AD_Value on neither tanks. I tried with empty tank and adding fuel but no changes.
If I switch and connect to 22 and 23 instead (tanks 3 and 4) I can get the right readouts. Am I doing something wrong ? The meters for tanks 3+4 are much smaller and I would prefer to have the sensors on tanks 1+2 which are much more readable.
Can I totally reset the tanks and start over ?
cheers
Per A.
RV-6A, Denmark