View Full Version : Fixed gear calibration

08-08-2016, 09:56 AM
With my older separate box unit - I did the calibration procedure this weekend. After the procedure was finished for flaps up and down, I got the landing gear warning continuously until I powered the unit off.

Is there a way to 'null' the gear warning in the 1LE page?
I don't specifically remember - but I think since the book said optional - I didn't wire the gear switch. Thinking I could simply wire that direct to ground....

Shawn McGinnis
08-08-2016, 12:51 PM
The simplest is to calibrate the landing gear value in the hanger like a HC. Also wiring that pin to ground works for disabling the alert.

08-12-2016, 10:38 AM
Thanks Shawn!