View Full Version : AeroSun VX Wiring with Quick Panel
TuppRV7
05-08-2016, 07:00 PM
Is there a recommended way to wire the Aerosun VX Wingtip lights for a Quick Panel system?
The Aerosun LEDs have 5 wires.
1. Red - Landing - 18 AWG
2. Yellow - Recognition (Wig-Wag) - 18 AWG
3. Blue - Taxi - 20 AWG
4. Green - sync? - 20 AWG
5. Black - Ground - 18 AWG
Shawn McGinnis
05-09-2016, 04:27 PM
The lights are wired into the Aircraft Rear connector.
LEFT
RED - Pin 13,25 L Lndg Light
BLACK - Ground
RIGHT
RED - Pin 7,20 R Lndg Light
BLACK - Ground
All the other wires aren't needed for the ACM.
http://advanced-flight-systems.com/Support/QuickPanelSupport/QuickPanelSupport.html#wiring
http://aeroleds.com/wp-content/uploads/2015/04/AeroLEDs-Wiring-Diagrams.pdf
DD RV7
10-13-2018, 07:32 PM
if the other wires (yellow, blue, green) aren't needed, will both landing and taxi lights come on when the landing light switch is actuated?
Shawn McGinnis
10-15-2018, 04:32 PM
The blue taxi connection can also be wired to an ACM-ECB. Sync and Wigwag are not needed.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.