rvdave
12-27-2015, 11:20 AM
I have the afs adsb module hooked up to my MFD, have verified power, ground, correct tx, rx pins and cannot get loop back information to read like I can on all other inputs. Is there a key required for adsb to operate on afs screen? Scan does not reveal anything in setup/cal mode. There is a red light flashing on adsb unit. I also don't see any weather options in any setup screen nor do I see anything indication of operation of adsb on screen.
ADSB mode= MASTER
ADSB data= NOT FOUND
Message count= 0000
Gps updates= 0000
I have serial inputs set correct to inputs in admin settings.
Have tried transponder settings to trigger adsb, I am sitting in the hangar with all antennae hooked up. Understand I may not receive antenna data but don't see any indication of system on
ADSB mode= MASTER
ADSB data= NOT FOUND
Message count= 0000
Gps updates= 0000
I have serial inputs set correct to inputs in admin settings.
Have tried transponder settings to trigger adsb, I am sitting in the hangar with all antennae hooked up. Understand I may not receive antenna data but don't see any indication of system on