PDA

View Full Version : Manifold Pressure Sensor Calibration



Frank D
07-30-2015, 03:43 PM
I can not find the MAP calibration process in the 5000 series manual, nor on a search of the forum.

In the set up menu I think there are 2 value points?

What is the process for the calibration?

Thanks
Frank

Shawn McGinnis
07-30-2015, 04:14 PM
Press SET -> Hold CAL
Use the joystick to navigate to Manifold and SELect

From here the parameters can be set. Allow the screen 15 minutes to reach a steady state before adjusting values.
First ensure the part number matches the device installed.
Next perform a shift adjust to the current airfield baro reading. The upper right hand corner reflects the adjusted value.

Frank D
07-30-2015, 05:41 PM
Are there 2 Cal Points? Can I reset them to factory prior to the shift adjustment?
Thanks,
Frank

Shawn McGinnis
07-31-2015, 01:14 PM
Changing the part number will reset the table back to factory standard.