BSteeves
07-09-2015, 02:04 PM
I have two 5600 screens each connected to its own magnetometer. Both have been calibrated a few different times but I can never get them to match up. Is it possible to get both screens showing the same heading?
Thanks
Shawn McGinnis
07-13-2015, 04:55 PM
Be sure to run the mag cal process on both screen at the same time. Magnetometers within 3-5° are normal. Cross check warnings show up at 25°.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.