PDA

View Full Version : Stacked magnetometers



TrueAirSpeed
03-06-2010, 11:54 PM
I 'm ready to install your Crossbow magnetometer for the 4500 along with one for the Dynon D6. I've read the installation instructions and don't see anything prohibiting me from "stacking" the two. I even contacted Dynon and they agree it would not be a problem. Any input from you?


Terry
RV-7

Rob Hickman
03-07-2010, 06:40 PM
Crossbow says that they should be 7" apart, I suspect that they would work fine stacked.

TrueAirSpeed
03-07-2010, 08:47 PM
Thanks Rob for the quick response.

Terry

RV7GUY
03-07-2010, 10:10 PM
Terry,

Where are you going to mount these in your 7? I'll be mounting some soon too.

Darwin N. Barrie
Chandler, AZ

TrueAirSpeed
03-08-2010, 08:14 AM
Reference: Location

Darwin, not in the wingtips (too many wires there already). Either on the aft deck, under the tail fairing with allowances for moisture or on a common shelf just aft of the baggage compartment bulkhead.

Terry
Prescott, AZ

kuku202
02-07-2015, 12:03 AM
Drawing 53600WD shows to terminate the shields of shielded cables to the ground screw on the EFIS case. The drawing does not show the other end of the shield grounded. Should they be? In the G430 installation manual the shield of every shielded data cable is grounded at both ends. Thanks