View Full Version : POS-12 wiring

04-11-2015, 02:46 PM
Using the POS12 for flap position to my 4500. Intended on running the 3 wires next to the power for flap actuator. They are not in a shielded bundle. Do I need to keep them separated and if so by how much? Or do I need to pull them and use a shielded run?

Rob Hickman
04-13-2015, 01:35 PM
They don't need shielded wire

04-13-2015, 07:15 PM
They don't need shielded wire

Just to be clear, they will be along side the actuator power wires. I was considering inductance during high current draw while lowering flaps.

Shawn McGinnis
04-14-2015, 06:06 PM
You can separate or shield the cables if you are concerned but we have not found this to be necessary.