PDA

View Full Version : Rotax CHT Wiring



recmob
03-31-2015, 11:45 AM
Wiring a clients AFS-5600 using the supplied Stein-Air harnesses that came with the package. According to the manual it says to wire DB37 pins 22 & 23 for the CHT's on the Rotax engine. The Stein-Air harness is already bundled into the panel wiring, only to find there are no sockets or wiring installed in the back shell in those locations. Are terminals 22/23 the correct current wiring, or should something else be used? If those are correct, where do I get the sockets to install them?

Shawn McGinnis
03-31-2015, 04:48 PM
Yes, you will need to pin a 22g wire with a M39029/63-368 (http://www.digikey.com/short/7fzvnt) into 22 and 23 for a Rotax engine. These are standardly unused connections for tanks 3 and 4 but adapted to work with the Rotax engine.

If you still are having trouble give us a call to order the additional wires.