PDA

View Full Version : Black screen on install test (but LED's!)



jdeas
12-26-2014, 05:29 PM
Just replaced my 4500 with the 5600.
Power was expanded to the two main power and two master gnd connections. I backup battery was also installed.
When applying power the Ethernet jack led's blink but the screen never comes up.
With only the backup battery, the Ethernet jack LED's blink while the button is being held down.

Ia there any reason the main screen would not come up if just the backup battery was connected? I tried the 40 second screen reboot but nothing happened.

Rob Hickman
12-26-2014, 10:28 PM
Try it with only the backup power connector to make sure you don't have a wiring problem.

Rob Hickman
12-26-2014, 10:30 PM
One led should be solid and one blinking, also make sure you are not trying it on a dead battery.

jdeas
12-27-2014, 07:15 AM
Pulled out and connected only the bu batt. LEDs, one solid one blinking while holding btn 1 down. Still a black screen.. also tried a second battery