PDA

View Full Version : Mounting 5600 to Aerosport panel



rvdave
12-20-2014, 03:18 PM
Doesn't look like the second bulkhead needs to be cut away for symmetrical panel but wondering about the alum panel insert the 5600 mounts to, much of that gets cut away for finish cut. Does that require some alum angle around the perimeter of the vertical edges? Or should all the screws holding the insert be sufficient? Similar to Robs installation--wondering what was done there?


Dave Ford
RV10
Aerosport Symetrical panel

Rob Hickman
12-20-2014, 06:00 PM
I just have the aluminum panels with press in nuts for the EFIS screws.

rvdave
12-20-2014, 09:12 PM
Ok sounds good

016hnoor
03-21-2015, 06:06 AM
Does that require some alum angle around the perimeter of the vertical edges?

Rob Hickman
03-22-2015, 09:26 AM
You don't need any aluminum angle. The AeroSport aluminum inserts get screwed through the carbon panel into the aluminum sub panel.