Activity Stream

Up to two charts are selectable to the right of the Map button. For more go to Layers and then you have all Charts displayed - I added Denmark

I'm running v15.01.23-MV16, and when I hit one of the -> -> /////, I am either not getting all of my data, or I am getting data from the wrong...

Ah, that makes total sense, thank you!

OK, thanks. Are my current sensors (oil/fuel pressure, MAP, oil temp) likely to have to be re-calibrated? (airplane is down briefly awaiting new...

At this time it is necessary to switch the cabin lights circuit on at every boot, and then you can use your dimmer knob to regulate lights for the...

There are three programmable inputs per EFIS screen, if you have an MFD screen you need to program the inputs from that screen directly. If your...

While it does not reference the Dynon 103757-000 part #, the new sensor is selectable (scroll all the way down) as KAVLICO 150 PSI FLUID HBP (AFS...

Thanks Jonathon. I checked the canopy latch, and yes, I do have the first two inputs wired to door closure sensors on each of the RV-10 doors. The...

In the AFS v16 software from December 2020, AFS doesn't have a drop down entry in the oil pressure and fuel pressure configuration pages specifically...

Jonathan, I have an AFS 5500 touchscreen with the Skyview network, internal EMS and version 16 is loaded and working. How do I manually enter the...

With the EMS-220 that MacCool is using, it is only possible to directly choose the correct sensor from the drop down list. For fuel PSI, this...

I have installed the high burst pressure replacement Kavlico sensors and according to the above post they are directly selectable as fuel and oil PSI...

Thanks Jonathon, will do

Cabin lights: this is due to be fixed in software soon so that the cabin lights circuit will be hot from bootup. Pitot: Go to SET--> CAL-->...

The most usual cause of a high or jumpy oil temp reading is that you have a bad engine ground. The fact that the reading goes back to normal when...

Excellent. I just ordered a couple. Will install them after I get the current arrangement running. If I can figure out how and where to install them.

Yes the high burst pressure replacement Kavlico sensors are directly selectable as fuel and oil PSI options on AF-5000 v16 software.

Thanks Jonathon. I'm aware that the 103757-000 (Dynon part number) 150 psi sensor now supercedes the previous sensors, but wasn't aware of the AFS...

Yes your inference is correct. You need to be aware, however, that both of these sensors are subject to last year's service bulletin regarding...

never mind

Hi Jonathon, Thanks for the quick reply. I found the up/down buttons on the bottom check-elec page to be backwards. So I reversed the polarity...